diamond truing tool used for attention

1 using the new dresser, before finishing the last feeding should exit. Many crisp diamond dressing tools, at the beginning of his contacts with the wheel, are easily damaged.
(2) in an inclined angle of 10 ~ 15 ° diamond dressing tool head mounted to point to the direction of rotation of the wheel.
3 securely installed or clamping dresser dressing tool, not the tool head hanging too long.
4 Where possible, try to use  carbide tipped saw blade coolant. Throughout the finishing time, with coolant pouring dressing tool and the wheel contact point.
5 In the dressing beginning from the highest point of repair from the grinding wheel, usually the middle wheel.
6 Note that except for a slight amount of repair. In addition to the maximum depth of repair, except for tinkering: 0.001 to 0.002 inches. Except for finishing: 0.0005 to 0.001 inches.
7 Press the relevant manuals choose the right lateral quickness. The slower moving laterally (in the allowable range), the lower surface roughness obtained wheel.
8 must be within the specified time interval for dressing the grinding wheel to prevent the wheel blunt, the grinding force increases.
9 at predetermined intervals, the toolholder the dressing tool rotating 1/8 turn, to ensure that the dressing tool is always sharp.
10 When the diamond dresser or tool head blunt or obvious change in peacetime, should be timely adjusted and replaced.
11 According to the diameter of  metal grinding wheel the wheel, the amount of a reasonable choice of diamond CARAT (pure diamond content), the larger wheel diameter, the larger the value of the selected CARAT diamond.
Incorrect:
1 diamond dressing tools in place to clamp head, be careful not to bump into the wheel surface.
2 can not be a single point diamond dressing tool head vertically aligned wheel center to be inclined generally 10 ~ 15 °.
3 heat dressing tools can not be "quenched" (refers to sudden cold). In the dry dressing must be kept trimmed twice the interval sufficient to heat the dressing tool cooling.
4 wheel surface can not be assumed to concrete cutting  have ideal flat. When trimming the beginning to find the highest point of the wheel position for trimming.
5, if possible, in addition to the amount of each wheel of the repair, the radius of the wheel can not be more than 0.001 inches. In addition to the amount of the repair is too large diamond dressing tool head can cause premature wear and often broken.