aligned with the saw table

1. Please alloy blades vertically hanging drying rack, be sure to avoid the damp places, do not place alloy blade flat on the floor or on a shelf, flat will lead alloy blade deformation.
2. When used, do not exceed the  stone drill bits specified maximum speed.
3. When used, it must take protective mask, gloves, helmets, safety shoes, safety glasses.
4. The installation Alloy saw, must make sure the saw table properties, uses, it is best to read the manual saw table to avoid loading the wrong, causing an accident.
5. The installation Alloy saw, must first check whether there is a split alloy saw blade, distort, fill level, lost teeth and other phenomena, and then install it.
6. Superhard alloy sharp serrated blade, prohibit the collision, fall to the ground, you must gently.
7. alloy saw blade, you must confirm whether the center hole of the blade firmly fixed on the saw table flange, a gasket must be good washer; Then, gently turn the hand to promote the saw blade, confirmed Whether the eccentric shaking.
8. Must alloy saw cutting direction indicated by the arrow direction of rotation aligned with the saw table. Do not install the opposite direction, the direction will lead out the wrong tooth installed.
9. Preroll time: Change alloy saw before use preroll one minute, let saw table into the working state, can be cut.
10. Before cutting, you must confirm whether the  brick saws use of alloy saw the material being cut and consistent.
11. Cutting material must be gently cut into the normal operation of the blade material is prohibited Forced straining hard to push.
12. Ban reversed, inverted transfer lead out tooth, dangerous.
13. Use abnormal sound heard and saw abnormal shaking, cut not usually, immediately stop operation, looking for anomalies reason, the replacement blades.
14. Cutting, the prevention of sudden stop of the blade material is cut intermediate. Cutting was stopped at the middle can cause jagged off, blade deformation.
15. After cutting please wipe the sanding belt   rust oil. Prevent blade rust.
16. When not sharp serrated teeth grinding again, you must get the manufacturers specify abrasive grinding technology, shop or store to grind, otherwise it will destroy the original jagged angles affect cutting accuracy and shorten the life of the blade.